Keysight U3810 Series Getting Started Guide
108
Uninitialized BeagleBone devices
You will only need to perform this when the BeagleBone LEDs do not scan and turn off after 10
minutes (only for Un-initialized BeagleBones and older Debian images).
For some un-initialized BeagleBones or BeagleBones loaded with older Debian images, the USER
button on the BeagleBone will need to be pressed and held until the four blue status lights all
illuminate to install the image.
With the SDcard installed, press and hold the USER button as power is applied to the BeagleBone
by connected the USB cable to your computer. Release the button when the four LEDs illuminate.
IMPORTANT - Remove the SD card while the BeagleBone is powered off. No LEDs should be
active on the BeagleBone board. The SD card can be set aside and no longer needed for these
labs.
9
Press the
PWR BTN
to power up the BeagleBone and verify the new image by connecting with
PuTTY and observing the revision in the login notes.
Hold until all four
LEDs (USR0, USR1,
USR2, and USR3)
light up.
Press and Hold
the
USER
button
Insert the SD
card here
Summary of Contents for U3810A
Page 1: ...Keysight U3810A Advanced IoT Teaching Solution Getting Started Guide ...
Page 78: ...Keysight U3810 Series Getting Started Guide 78 IMU Characteristics from the LSM9DS1 datasheet ...
Page 131: ...Keysight U3810 Series Getting Started Guide 131 ...
Page 132: ...Keysight U3810 Series Getting Started Guide 132 Disassembly ...
