Keysight Technologies N4373D, User Manual

Page: 73 / 176

User Interface Reference
Keysight
N4373D Lightwave Component Analyzer, User’s Guide 71
Saving and Loading Setups
Saving setups
A setup contains the current state of the LCA user interface and
optionally also the current state of the network analyzer. Setups
are stored as XML-files or as compressed XML-files.
The settings on the “Tools” tab are not saved in the setup, since
the settings shown on this tab always reflect the current state of
the LCA hardware. After loading the setup the LCA system is
configured to press “Start” from the LCA user interface.
There are two ways of saving setups.
First saving method
Click to save the current setup.
• If user calibration mode is set to “Measure” (only possible for
OE and OO measurements), you are asked to specify the
electrical calibration set to be saved with the setup.

This is the electrical calibration set to be used during user
calibration measurements.
Only a link to the electrical calibration set is saved, not the
calibration data itself.
For more details, see “Measuring Opto-Electrical (OE)
Devices” on page 89 or “Measuring Optical-Optical (OO)
Devices” on page 101.
• If User Calibration is set to “Load” (only possible for OE and
OO measurements), you will be asked to specify which user
calibration file should be loaded.
The filename of the calibration data is saved with the setup,
not the calibration data itself.
For more details, see “Measuring Opto-Electrical (OE)
Devices” on page 89 or “Measuring Optical-Optical (OO)
Devices” on page 101.
Second saving method
After initializing with the User Calibration mode set to
“Measure”, you are asked if you want to save the user calibration
data and/or the LCA Setup.