KEPCO BOP 1000W, Operator'S Manual

Page: 150 / 188

A-6
BIT 4886 080709
A.17 *TST? — SELF TEST QUERY
*TST?
Syntax : *TST? Returned value: 7 bits coded per Table A-4.
Description: Power Supply test. This query causes the power supply to do a self test and provide the controller
with pass/fail results. A 0 is returned if the unit passes the test. If the unit fails, a number from 1
through 128 is returned to indicate the cause of the error. The test executes each of the subtests even
when any one fails. If any test fails an error code bit is set which is returned to the user. The error
codes returned are listed in Table A-4
A.18 *WAI — WAIT-TO-CONTINUE COMMAND
*WAI
Syntax : *WAI Response:
Description: Causes the power supply to wait until all previously issued commands and queries are com-
plete before executing subsequent commands or queries.
This command can be used to guaran-
tee sequential execution of commands and queries. When all pending operations are complete (all
previous commands have been executed, changes in output level have been completed), the WAI
command is completed and execution of subsequent commands can continue.
TABLE A-4. BUILT-IN TEST ERROR CODES
TEST ACTIVE ERROR CODES
MEANING
*tst? DIAG:TST? BIT VALUE
Yes Yes 0 Pass (No error)
Yes Yes 0 1 ROM error
Yes Yes 1 2 RAM error
Yes Yes 2 4 FLASH error -- Perform calibration to correct
Yes Yes 4 16 Analog Communication error
No Yes 5 32 Loop Back Test error
No Yes 6 64 Max Voltage Output error
No Yes 7 128 Min Voltage Output error