3-17
Setting the Output Span
DDA-08/16 boards are shipped with the output span for all quad DACs
set to 10V. If this is not appropriate for your application, you can
reconfigure the output span for each quad DAC using the 3-position
output span switch.
The output span switches are labeled as shown in Table 3-6. Note that the
DDA-08 board does not contain the output span switches for quad DAC2
and quad DAC3.
Note:
The default analog output range for each quad DAC in the
DriverLINX default configuration is 0 to 10V (indicating a 10V span).
Make sure you note the switch settings on the board so that you can
program the DriverLINX configuration to match.
The locations of the output span switches on the DDA-08/16 boards are
shown in Figure 3-1.
Find the switch for the appropriate quad DAC. Slide the switch to the top
position for a 20V span; slide the switch to the middle position for a 10V
span; slide the switch to the bottom position for a 5V span or for current
output.
Table 3-6. Output Span Switches
Quad DAC
Label
Quad DAC0
S5
Quad DAC1
S6
Quad DAC2
S7
Quad DAC3
S8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com