3-18
Setup and Installation
Figure illustrates the setting for a 10V span.
Figure 3-5. Setting the Output Span
Installing the Board
Before installing a DDA-08/16 board in your computer, make sure that
the switches are set appropriately. Make sure to note the switch settings
so that you can match these settings when you program the configuration
using DriverLINX. Refer to the DriverLINX Installation and
Configuration Guide and Using DriverLINX with Your Hardware,
Keithley DDA-08/16 manuals.
Refer to the documentation provided with your computer for more
information on installing boards.
Caution:
Make sure that power is turned OFF. Installing or removing a
board with the power ON can damage your computer.
To install the board, perform the following steps:
1. Turn power to the computer and all attached equipment OFF.
2. Remove the computer chassis cover.
3. Select an available slot. DDA-08/16 boards require a full-size slot.
4. Loosen and remove the screw at the top of the blank adapter plate,
and then slide the plate up and out to remove.
5. Insert and secure the board connector in the selected slot.
6. Replace the computer chassis cover.
5V/Current
20V
10V
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com