O p e r a t i n g I n s t r u c t i o n s
|
KBL Tower pureEnergy
8
SALTY AIR - CONTAMINATED AIR
Salty air, contaminated air may lead to
corrosion of the housing and electrical
components.
Damage to the tanning
device possible!
• Do not operate the tanning device in
locations with aggressive environmental
conditions (e.g. air containing chlorine).
• Do not install the tanning device at swim-
ming pools.
DIFFERENCE IN TEMPERATURE
Risk of damage by switching on the
power supply voltage.
When there are great differences in tempera-
ture between the transportation route and the
installation site the tanning device shall not be
put into operation immediately after being set
up.
• Before connecting the tanning device
to the power supply, wait at least for
2 hours.
1.10 Commissioning
DANGER
Damaged mains power cable
Risk of fatal injury due to electric shock
when touching a damaged mains power
cable.
• Only the manufacturer or specialized
companies may replace the mains
power cable!
Initial commissioning will be carried out by the man-
ufacturer’s own service technicians or by qualified,
trained and authorized service technicians. The tan-
ning device will be handed over ready for use.
As studio operator it is your responsability to observe
the electrical regulations applicable at the installation
site.
The tanning device incorporates special preventive
measures with regard to the electromagnetic com-
patibility and must be installed and commissioned
according to the EMC instructions obtained from this
operating instructions.
If the tanning device has not been used for a lon-
ger period of time, then it must fi rst be inspected by
qualifi ed, trained and authorized service technicians,
before being put back into operation again.
1.11 Obligations of the studio
operator
• The studio operator is responsible for informing
users on possible risks of tanning.
• All danger and safety labels attached to the tan-
ning device must be observed and shall not be
removed!
• The tanning device shall only be used when in
proper operational condition!
• The studio operator is responsible to ensure that
the tanning device is handled properly.
• No safety equipment (e.g. thermal switch) shall
be removed, deactivated, or otherwise bypassed
as it may impair the safe operation of the tanning
device!
• The electrical installation shall have a freely acces-
sible, all-pole disconnecting device (Master switch
with clearly labeled On/Off settings, e.g. ‘0’ and ‘I’
or additional indicator light) fi tted externally on the
site side.
Summary of Contents for Tower pureEnergy
Page 1: ...OPERATING INSTRUCTIONS TANNING DEVICE ...
Page 59: ...O p e r a t i n g I n s t r u c t i o n s KBL Tower pureEnergy 60 Remarks ...
Page 61: ...O p e r a t i n g I n s t r u c t i o n s KBL Tower pureEnergy 62 Remarks ...
Page 62: ...Ringstraße 24 26 56307 Dernbach Germany fon 49 0 26 89 94 26 0 fax 49 0 26 89 94 26 66 ...