19 of 48
5.1.6 Installing the Turntable
The sequence of pictures shown illustrates all the necessary installation steps that are required to install
the turntable and the pre-assembled flat antenna on the roof of the vehicle. However, follow the other
detailed instructions in this installation and operating manual!
1. Determine the installation location. Note the following:
●
Swing path of the system = Ø 96 cm
●
Drill a hole with Ø 38 mm for the cable gland
●
Deburr any sharp edges of the hole
See also
5.1.3 Selecting the Installation Location, p.13
ff
2. Apply the sealing adhesive to the spigot of the roof
duct. Insert the spigot into the hole and secure it from
below with the knurled nut.
3. Unscrew the screws (x 6, 10 AF) from the mounting
plate and remove the mounting plate.
4. Place the turntable on prepared wooden supports to
protect the roof of the vehicle.
5. Align the mounting plate with the arrow pointing in
the direction of travel. The arrow is marked with
①
at
step 8 in the illustration.
6. Mark out and drill the six holes to secure the mounting
plate (see
5.1.4 Installing the Cable Gland and
Mounting Plate, p.14
, Fig. C).
7. Apply the sealing adhesive in a wavy line between the
two grooves and spread it with a spatula or similar.
Risk of skin injuries!
►
Avoid any skin contact with the
adhesive sealant.
►
Note the safety information of your
adhesive.
Summary of Contents for CAP 650 GPS
Page 37: ...37 of 48 10 2 Dimensions in mm 144 5 65 5 ...
Page 47: ...47 of 48 ...
