22 of 48
Installation and Connection
5.1.9 Connection Example for 12 V Battery Connection
CAPcontrol app*
control & streaming
Ignition
12V
CAP Converter
control unit
HDS 50*
separate control panel
TV set 2
with satellite tuner
UFZ 131*
Wi-Fi Hotspot
TV set 1
with satellite tuner
Slave coaxial cable
Master
coaxial cable
Power supply cable
When operating with two batteries, ensure that the ground of the ignition signal is at the same potential
as the ground of the supply battery for the turntable. potential as the earth of the supply battery for the
turntable. Otherwise the automatic automatic lowering will not work! Do not reverse the polarity of the
cables!
In order for the GPS data to be read and the antenna to automatically lower itself into the parking posi-
tion, the green wire must be connected to the ignition and the red and black wires to the power supply.
5.2 Installation and Connection of the CAP Converter
5.2.1 Selection of a Suitable Installation Location
When choosing the installation location, bear in mind that the rear of the CAP converter should always be
accessible. The CAP converter is equipped with a power saving circuit, which means that the unit does not
need to be placed where it is visible. You can therefore fit the CAP converter out of sight in any location,
e.g. on cupboard walls, side walls or the base of storage compartments.
The four screw sockets provided (see
Preparing the CAP Converter for Installation
, p. 24) allow you to
place the CAP converter not only on a firm even surface but also to fix it there or mount it in other posi-
tions.
Summary of Contents for CAP 650 GPS
Page 37: ...37 of 48 10 2 Dimensions in mm 144 5 65 5 ...
Page 47: ...47 of 48 ...
