17 of 48
–
Use a clean colourless cloth to remove any adhesive sealant that leaks out at the sides. Pay attention to the
following:
~
Do not use any cleaning agents or thinners containing solvents, as this could damage the adhesive sealant
applied under the mounting plate.
~
It is recommended to soak the cloth in acetone or MEK. Apply the cloth soaked in acetone or MEK to an incon-
spicuous area to make sure that it does not adversely affect or damage the surface.
~
Use only cleansing paste and water to clean your hands.
–
Secure the cable gland from inside the vehicle by tightening the ribbed nut supplied (Fig. A).
–
Note that the curing of the adhesive sealant depends on the ambient temperature and the humidity. Please refer
the final strength the data sheet of your sealing adhesive. However, this need not restrict further installation work,
since the mounting plate is held in place by the tightened screws.
5.1.5 Installation of the Turntable
Variant with cable gland underneath the turntable
1. Feed the ends of the cables with the connectors as far as possible through the cable duct into the interior of the
vehicle.
2. Lift the turntable and place it carefully on the mounting plate in the direction of travel (see Fig. E). Do not step on the
connectors or kink or crush the cables!
3. The through holes on the turntable must be perfectly aligned with the threaded holes on the mounting plate. When
lowering, make sure that the cables are fed through the cable gland and are not crushed.
4. Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening screws into
the thread. Tighten the screws to a torque of 6 Nm.
5. To prevent water vapour from inside the vehicle reaching the turntable through the roof duct, thread the three cables
through the sealing gasket supplied, fold it and insert it into the roof duct until it reaches the stop (see Fig. E). Make
sure that no tensile load is acting downwards on the sealing gasket as this can cause it to fall out in the course of
time.
Fig.
E
Gasket with plug for
the unused duct
Battery/ignition
CAP converter,
second TV/Receiver
Summary of Contents for CAP 650 GPS
Page 37: ...37 of 48 10 2 Dimensions in mm 144 5 65 5 ...
Page 47: ...47 of 48 ...
