12 of 48
Installation and Connection
5
Installation and Connection
5.1
Installing and Connecting the Turntable
5.1.1 Required Tools and Equipment
●
Circular cutter, Ø 38 mm
●
Flat-bladed screwdriver for M5 screws
●
Power drill
●
The following screws, depending on the roof structure:
–
galvanised round head screws, Ø: 5 mm, sheet metal
screws D 7981 or
–
round head screws D 7985 with washers and nuts
●
Twist drill, Ø 2.5 or 5.5 mm
●
Round file and/or emery paper
●
Cleaning agent
●
Open-ended or ring spanners 10 and 11 mm across flats
●
Knife
●
Cross-head screwdriver for M3 and M5 screws
●
Torque wrench capacity 6 to 11 Nm
●
Hexagon socket key, 5 mm
●
Two wooden beams for supporting the turntable
●
Adhesive sealant (not included in the delivery)
5.1.2 Unpacking and Preparing
Risk of material damage during transportation!
►
Never carry the turntable by the flat antenna.
►
Keep the turntable in its cardboard box for transport on to the vehicle roof.
Unpacking the turntable
The packaging of the turntable can be opened along
the centre. This makes it easier to access the fastening
screws once the system and inserts have been taken out
of the packaging.
Retain the original packaging: If it is necessary to send
the unit for repair, use the original packaging to prevent
transport damage. The manufacturer accepts no liability
for possible damage.
Preparing the turntable
1. Loosen the six fastening screws (width across flats: 10 mm).
2. Carefully lift the turntable off the mounting plate and place it on the two prepared wooden supports. Make sure that
the cables are not crushed where they emerge from the underside of the turntable.
Summary of Contents for CAP 650 GPS
Page 37: ...37 of 48 10 2 Dimensions in mm 144 5 65 5 ...
Page 47: ...47 of 48 ...
