Kaliburn Spirit150a, User Manual

Page: 66 / 164

Operation Spirit200a User’s Manual Rev J
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
4-24
Cutting Charts
The cutting charts shown on the following pages are intended to give the
operator the best starting point to use when making a cut on a particular
material type and thickness. Small adjustments may have to be made to
achieve the best cut. Also, remember that the arc voltage must be
increased as the electrode wears in order to maintain the correct cutting
height.
Cutting Chart Index
Material Current Plasma Gas Shield Gas
Copper
Electrode
Silver
Electrode
Mild Steel 30 Amps Oxygen Oxygen 4-25
Mild Steel 50 Amps Oxygen Oxygen or Air 4-26
Mild Steel 70 Amps Oxygen Air 4-27
Mild Steel 100 Amps Oxygen Air 4-28
Mild Steel 150 Amps Oxygen Air 4-29
Mild Steel 200 Amps Oxygen Air 4-30 4-47
Stainless Steel 30 Amps Air Air 4-31
Stainless Steel 50 Amps Air Nitrogen 4-32
Stainless Steel 70 Amps H17 Nitrogen 4-33
Stainless Steel 70 Amps Air Nitrogen 4-34
Stainless Steel 100 Amps H17 Nitrogen 4-35
Stainless Steel 100 Amps Air Nitrogen 4-36
Stainless Steel 150 Amps H17 Nitrogen 4-37
Stainless Steel 150 Amps Air Nitrogen 4-38
Stainless Steel 200 Amps H17 Nitrogen 4-39
Stainless Steel 200 Amps Air Nitrogen 4-40 4-48
Aluminum 30 Amps Air Nitrogen 4-41
Aluminum 50 Amps Air Nitrogen 4-42
Aluminum 70 Amps Air Nitrogen 4-43
Aluminum 100 Amps Air Nitrogen 4-44
Aluminum 150 Amps Air Nitrogen 4-45
Aluminum 200 Amps Air Nitrogen 4-46 4-49