■ Remove all covers
■ Seal the floor pan (option)
Covering the intake openings on both air filters:
1. Cover the intake opening on the engine air filter.
2. Cover the intake opening on the compressor air filter.
Covering sensitive components:
1. Check that the control panel cover of the SIGMA CONTROL SMART is closed.
2. If necessary, close the control panel cover.
Result Sensitive display instruments are protected against splash water.
Setting the high-pressure washer:
➤ For setting the high-pressure washer, see chapter 51.
High-pressure washer
Value
Interior diameter of the jet nozzle [mm]
6.3
Flow rate [gal/min]
3.3
Tab. 51 High-pressure washer setting
Cleaning the interior of the machine:
Precondition Set the high-pressure washer as per the values given in Table 51.
1.
Jet water can damage the machine!
Jet water can damage or destroy electrical components and sensitive display instruments.
➤ Do not direct jet water at electrical components.
2. Do not direct jet water at the starter, control box or sensitive display instruments.
3. Do not direct jet water at solenoid valves or electrical plug-in connections.
4. Do not direct jet water at the starter battery/batteries.
5. Clean non-sensitive components/surfaces inside the machine.
Whilst cleaning, keep the extension pole of the high-pressure washer in constant motion.
If water accumulates in the closed floor pan:
➤ Remove the plugs.
➤ Allow the water to drain out.
For information on draining liquids from inside the machine, see chapter 10.11.
Removing all covers:
1. Remove the cover from the engine air filter intake opening.
2. Remove the cover from the compressor air filter intake opening.
Result The plastic sheeting and adhesive tape is removed from the interior of the machine.
8
Operation
8.5
Cleaning the machine after operation
No.: 901779 08 USE
Operator Manual Portable Rotary Screw Compressor
MOBILAIR M58utility SIGMA CONTROL SMART
81
