Appendix
105
Messages On the Display
When an error message appears
Sample screens shown below may vary depending on the display pattern.
Error message
Cause and Remedy
The batteries have run out. Turn the power off and replace all the
batteries with new AA alkaline batteries. Also, make sure that the
batteries are inserted with correct polarity. It is recommended that
you use the AC adapter that comes with the product as much as
possible.
See
"Connecting the AC adapter" (p.25).
See
"Installing the batteries " (p.26).
The tape cartridge is not installed or not installed correctly.
Turn the power off and reinstall the tape cartridge correctly.
See
"Installing tape cartridges" (p.28).
Tape cartridge that is not supported by the LABELShop
£
BEE3 is
installed, or the cartridge is installed incorrectly. Turn the power off
and check the cartridge and replace it if necessary.
See
"Installing tape cartridges" (p.28).
The printhead is overheated due to the continuous printing.
Turn the power off, remove the tape cartridge, and leave the device
until it cools down.
The device cannot print the label or display the print image as the
installed tape cartridge is not wide enough for the entered text.
Press any key to return to the text enter screen, then install the
wider tape cartridge or delete some lines.
See
"Adding New Lines (Line Break)" (p.49).
Change
Batteries
No Tape!
Check Tape
Cartridge!
Over Heat!
Line Over!
Summary of Contents for BEE3
