D*AP4 VAP
36
Below is the Status page of the
DANTE
interface board:
The parameters you see here must be set via the
DanteController
software.
Dante
Device Name
The name you gave the interface board via the
DanteController
.
Primary Network Status
[Offline / Con bandwidth]
Secondary Network Status
[Offline / Con bandwidth]
Clock Synchronization
Mute Status
[OK (Unmuted) / Muted]
Sync Source
[Dante Network / DA*P is Master]
Here you define
the reference clock for this
DANTE
module.
Important Note!
If this parameter is set to "Dante Network", the
D*AP
must be synchronized to the same
clock as the network clock master (whoever it is). It
must
be set to "Dante Network" if this module is to
become the "Preferred Master" of the network.
Sync Status
[Unlocked / Locked / Locked-Async]
The sync source for the
DANTE
interface is the
DANTE
network.
If no network cable is connected the interface is "Unlocked". If it is
connected to a network it will be "Locked". If the
D*AP VAP
is set to
synchronize to other than the
DANTE
interface it will show
"Locked-Async".
Preferred Master
[No / Yes]
The Dante algorithm automatically looks for the best clock master
inside the network but one may force a
DANTE
module to become
the clock master.
Network Audio Sample Rate
[44.1kHz / 48kHz / 88.2kHz / 96kHz]
Depending on the A*P device type the sample rate is limited to the
device specification.
Device Latency Setting
[1000 µs]
You can allow for a certain transmission latency if you face network
problems of any kind.