JUMO AQUIS 500 RS, Operating Manual, Page: 40 / 120

6 Operation
40
✱
ADMINISTR. LEVEL > PASSWORD > PARAMETER LEVEL > SWITCH
OUTPUT 1 OR 2/MANUAL MODE: set INACTIVE or ACTIVE.
INACTIVE => Relay K1 or K2 drops out
ACTIVE
=> Relay K1 or K2 picks up
Deactivating simulation
✱
ADMINISTR. LEVEL > PASSWORD > PARAMETER LEVEL > SWITCH
OUTPUT 1 OR 2/MANUAL MODE: set NO SIMUL.
No simulation = No MANUAL mode; the JUMO AQUIS 500 is in control.
6.10.3 Simulation of analog outputs using MANUAL mode
Enabling and
activating
✱
Select activation for simulation of the actual value output:
ADMINISTR. LEVEL > PASSWORD > PARAMETER LEVEL > ANALOG
OUTPUT 1 OR 2 > SIMULATION: OFF or ON.
If "ON" is selected, the output adopts the value of the "SIMULATION VALUE"
parameter.
If the device is back in measurement mode, "MAN." appears at the top right of
the LCD display in the status line.
Deactivating
✱
ADMINISTR. LEVEL > PASSWORD > PARAMETER LEVEL > ANALOG
OUTPUT 1 OR 2 > SIMULATION > Off.
The relevant output of the JUMO AQUIS 500 resumes operation.
If the device is back in measurement mode and no other output or controller is
in MANUAL mode, "MAN." disappears from the top right of the LCD display in
the status bar.
6.10.4 MANUAL/simulation overview
It is possible to display which outputs or controllers are in MANUAL mode.
The device is in "normal display" mode.
✱
Press the key several times for less than 2 seconds (number varies
according to the features and configuration of the device).