– 49 –
3) Wire the cord of proximity sensor
along with
the other cords as illustrated in Figs. 4 and 5
and bundle it at four locations
B
with accessory
cable clip bands. In addition, secure it with other
cables with cable clip
C
which is originally at-
tached as shown in Fig. 4.
4) Connect the connector of cord
to the CN97
(red) of the INT PCB in Fig. 3.
9) Connect the connector of motor cord
to the
CN56 (white) of CTL PCB.
10) Fix motor cord
and attach the control box
cover according to
.
C
B
D
F
E
B
Fig. 4
Fig. 5
G
CN56
Fig. 6
B (Bind cord
)
B (Bind cord
)
5) Attach INT PCB cover
with two screws
❽
and bundle the cords with cable clip band
❾
as shown in
Fig. 3.
At this time, fix the cords taking care not to allow them to sag so as to prevent the flat cable, etc. from
coming in contact with the feed converter fulcrum shaft
H
.
6) Attach top cover
❶
and motor cover
❻
respectively with the screws. Carefully attach motor cover
❻
while preventing the outer periphery of handwheel to friction against motor cover
❻
when turning the
handwheel.
7) Detach the electrical box cover. Refer to
"2-14. Connecting the cords" p.16
cover.
8) Routing motor cord
along the groove existing between top cover
❼
and the machine head as illus-
trated in Fig. 4, secure motor cord
in tapped hole at section
D
of rear cover
with accessory cable
clip
E
and screw
F
. Then, pass the cord to the undersurface of table through the hole at section
G
.
H