– 69 –
(3) Adjusting the lower stop position
WARNING :
The needle bar moves during adjustment of this item. Be careful not to place your fingers under the
needle.
<Sewing screen (Maintenance personnel mode)>
1) Press
❶
on the sewing screen under
the maintenance personnel mode.
The "sewing data edit screen" is displayed.
<Sewing data edit screen>
<Needle bar lower stop position setting screen>
3) Adjust the lower stop position of the needle
bar following two different adjustment proce-
dures described below.
[Adjustment with the + / - key]
Adjust the needle bar position with
❸
.
(Value shown in display
❹
will change accord-
ingly.)
[ Adjustment with the main-shaft angle ]
Adjust the needle bar position by turning the
main shaft with jog dial
⑧
etc. (Value shown
in display
❺
will change accordingly.)
Press
❻
to reflect the adjustment value
to
❹
.
4) The operation is confirmed by pressing
❼
. Then, the screen returns to the "sewing
data edit screen".
❶
❷
❸
❼
❺
❻
❹
2) Press
❷
.
The "needle bar lower stop position setting
screen" is displayed.
⑧
If you have changed the lower stop po
-
sition of needle bar, check to make sure
that the needle bar does not interfere
with the intermediate presser when you
operate the presser lifter. If they interfere
with each other, change the amount of
lift of the presser foot. (Refer to
List of pattern functions" p.71
)
