− 65 −
No.
Item
Setting range
/
Edit unit
Initial value
Corner knife motor origin compensation
Origin of corner knife motor is compensated.
−5.0 to 5.0
/
0.1mm
0.0mm
Marking light origin compensation (just under)
Origin of marking light motor is compensated. Origin is in the state that
it irradiates light just under and located at the position of 230 mm from
needle.
*
In case of
Long and wide type, light irradiation position is at
the position of 246 mm from the needle.
−500 to
500
/
1 pulse
0 pulse
Marking light origin compensation (needle side)
Position of needle side from origin of marking light motor is compensat
-
ed. Light irradiation position is 80 mm from needle.
*
In case of
Long and wide type, light irradiation position is at
the position of 96 mm from the needle.
−500 to
500
/
1 pulse
0 pulse
Marking light origin compensation (operator side)
Position of operator side from origin of marking light motor is compen
-
sated. Light irradiation position is 380 mm from needle.
*
In case of
Long and wide type, light irradiation position is at
the position of 396 mm from the needle.
−500 to
500
/
1 pulse
0 pulse
Back tack motor origin compensation
Origin of back tack motor is compensated.
−30 to 30
/
1 pulse
0 pulse
Summary of Contents for APW-895NE
