JUKI APW-895NE, Instruction Manual

Page: 31 / 256

− 15 −
Pass the needle thread in the illustrated order.
Left-hand side needle thread toward
the sewing machine
A
Right-hand side needle thread toward
the sewing machine
B
②
Then pass needle thread in the order as shown in the figure below.
Periodically replace thread guide felt C . Sewing trouble due to rough motion of thread
during sewing can be prevented.
A
A
B
A
B
A B
C
B
A B
A
B
❶
Pin
A
2. HOW TO REMOVE THE SEWING TABLE
(1) When replacing the bobbin thread
①
Move the clamp foot to the rear end of its stroke.
② Insert your fingers into notches A in the bottom
of right- and left-hand sewing tables
❶
and
❷
,
and push up the sewing tables.
③
Move the tables in the direction of the arrow
keeping the above state, and you can see the
bobbin case.
At this time, move the sewing tables
so as not to allow the sewing tables to
come in contact with the needles.
④ After replacing the bobbin thread, return
the sewing tables in place by following the
above-mentioned steps of procedure in the
reverse order. Now, firmly set the sewing tables
on the throat plates and the pins.
❷
CAUTION
:
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.