www.modelflight.com.au
– World’s best source of JR products
PITCH CURVES
12J
Adjustment of the pitch curve is very
similar to the throttle curve adjustment
described in the preceding section. A
thorough understanding of the Throttle
Curve Section will make pitch curve
adjustment easier to understand.
Go to Throttle Curve menu
There are three independent types of
pitch curves available: Normal, Stunt,
and Hold. Each pitch curve contains five
adjustable points: LOW, 1, MID, 3 and
HIGH.
Note
: The pitch curve for the Throttle
Hold function can only be set if this
system is activated.
Change value/Switch selection
[PITCH]
NORM
I 1
O 1
Go to Throttle Cut menu
Select function to change
Reset POS value to O
or
Inhibit function
Accessing the Pitch Curve Function
1. Place the transmitter switch in the
On position.
2. Press the
D o w n
and
Select
keys
simultaneously to enter the
Function mode.
3. Press either the
U p
or
Do w n
key until
PITCH
appears in the top of the LCD.
Note
: Use NORMAL for hover curves
and STUNT for stunt curves. We will
concentrate on the hovering curve
during this example.
4. Press the
Select
key to select the point
of the curve you want to change.
5. Press either the (+) or (-) key to
change the value of the current curve
point. The range of each point is
0–100% in .5% intervals.
Note
: In each curve, the factory setting
INH indicates Inhibited for points 1
and 3. These values are 25% and
75% respectively, if no value
changes are made to any other
points. If any of the other points have
been changed while these points
were inhibited, the inhibited points
will change to plot a smooth curve. If
you want to keep this from
happening, press the
Select
key to
display the positions 1 and 3, then
press the (+) or (-) key to activate
each point.
6. To set curves for STUNT mode, press
the
Select
to highlight the NORM
function, then press the (+) or (-) key to
select the STUNT function. Repeat
Steps 4 and 5 to complete the
procedure.
7. To set the curves for the Throttle Hold
mode ‘’H’’, press the Up key once
again until ‘’H’’ is displayed, and
repeat steps 4 and 5.
8. Access the
REVO MX
function by
pressing the
U p
key.
9. Access the
THROTTLE CURVE
function by pressing the
D o w n
key.
10. Exit the
PITCH CURVE
function by
pressing the
D o w n
and
Select
keys
simultaneously.
XP6102 - Helicopter Manual
75
