www.modelflight.com.au
– World’s best source of JR products
THROTTLE HOLD
12H
The Throttle Hold function is designed to
hold the throttle servo in a specific
position during an autorotation. This is
very useful for practicing autorotation
landings. The throttle hold switch can be
programmed to one of the four toggle
switches. Throttle hold will always be
"On" in the forward switch position and
"Off" in the rear position.
Go to Throttle Curve menu
Change value/Switch selection
[THROTTLE HOLD]
POS
O
OFF
SW
RIGHT
Go to Throttle Cut menu
Select function to change
Reset POS value to O
or
Inhibit function
Accessing the Throttle Hold Function
1. Place the transmitter switch in the
On position.
2. Press the
D o w n
and
Select
keys simultaneously to enter the
Function mode.
3. Press either the
U p
or
Do w n
key until
THROTTLE HOLD
appears across the
top of the LCD.
4. The factory setting for the throttle hold
is inhibit. Pressing either the (+) or (-)
key will activate Throttle Hold and
display the current throttle hold value.
5. Using the (+) or (-) key, adjust the
throttle hold value to deliver the proper
engine idle rpm for your helicopter. The
adjustable range is (-20%-+50%). Once
you establish the proper idle value for
your engine, you can use this value for
throttle hold as well. To shut the engine
off for autorotation, a negative or zero
value should be input.
Note
: When the throttle hold is
activated, and the switch is on,
the indicator on the LCD will
change from Off to On. In addition,
the throttle trim indicator will
be inhibited.
6. Access the
THROTTLE CURVE
function by pressing the
U p
key.
7. Access the
THROTTLE CUT
function
by pressing the
D o w n
key.
8. To exit the
THROTTLE HOLD
function, press the
D o w n
and
Select
keys simultaneously.
XP6102 - Helicopter Manual
71
