41
7-6
CONTROL LEVER/LINKAGE ADJUSTMENT
2.
Next, check to be sure the Swashplate Assembly is at 90° in all directions
(Fore/Aft, Left, Right) to the Main Rotor Shaft Assembly. If this is not the case,
adjust Control Rod , making sure that both the Roll (1 pc) and Elevator
(2 pc) Bellcranks remain positioned parallel as shown. Also check to insure that
control rod is sized 8mm as shown below.
Note:
The following adjustments are made with all
servos in the center (1/2 stick) or neutral positions.
To Servos
Servo Mixing Arms
Adjust Here
Parallel Line
Mixing Base Arms
A
B
B
C
3.
Check the Seesaw Mixing Arms (2) and adjust so
that with the Flybar Assembly Level, and the Pitch at 1/2
stick (center), the Mixing Arms are level (parallel) as
shown. If this is not the case, adjust the Control Rod
(2) until this positioning is achieved. Adjustment of the
Main Rotor Blade Pitch to the desired settings can be
achieved by using Control Rod for adjustment. See
page 46 Section 6A for Pitch range settings.
B
A
B
A
B
C
Main Rotor Shaft Center Line
Adjust Here
Roll Bellcrank
Elevator Bellcranks
To Servos
Swashplate
Control Rod
Parallel Line
Make certain Flybar is level
Adjust Mixing
Arm Angle Here
Seesaw Mixing Arm
Adjust Main Rotor
Blade Pitch Here
Be certail all Bellcranks
remain parallel at neutral.
90°
8mm
1.
Check to insure that both the Elevator (2) and Aileron (1)
Servo Mixing Arms are parallel (same angle) to the Mixing
Base Arms (2) with all servos in the neutral (center) positions.
If these items are not parallel, re-adjust the Control Rods
until proper alignment is acheived.
B
A
C
Z,Q
Summary of Contents for Ergo Z230
Page 43: ...43 TEAM JR DECAL PLACEMENT Tail Boom Body Stabilizer Fin ...
Page 71: ......
