JR ProPo Ergo Z230, Assembly Instructions Manual

Page: 29 / 72

5-3
TAIL CENTER HUB ASSEMBLY
5-4
TAIL BLADE HOLDER ASSEMBLY
29
Slide the Tail Slide Ring Assembly on the Tail Output Shaft before installation
of the Tail Rotor Hub. When attaching the Tail Rotor Hub, be certain that the
two 3x3mm Set Screws engage into the holes at the end of the Tail Output.
*Tail Rotor Blade (2 pc)
Tail
3x15mm Socket Head Bolt
2mm Hex Nut
Steel Joint Ball
Tail Blade Holder w/Flange
(Outside)
Tail Center Hub
Tail Blade Holder Bearing
(Sealed) (2 pc)
Tail Thrust Bearing
3x3mm Set Screw (2 pc)
Tail Slide Ring Assembly
10x7mm Washer (Large)
Large I.D.
Small I.D.
7x4mm Washer (Small)
Tail Blade Holder Bearing (Open) (2 pc)
3mm Lock Nut
3mm Lock Nut
Caution: Be sure to note correct
placement of Large/Small I.D.
Thrust Washers during assembly
When assembling, check to make sure
the Tail Blade Holder Bearings can rotate
freely, without play. If binding occurs,
loosen the 3mm Lock Nut Slightly.
2x8mm Socket
Head Bolt
3mm Lock Nut
*Be sure to note the correct direction
of the Tail Rotor Blades during
assembly.
Rotation Direction
Leading Edge
2x10mm Flat
Head Screw
Connect the Tail Pitch
Links to the Steel
Control Balls after the
Tail Blade Holders have
been assembled.
....2 pc
3x3mm Set Screw
....2 pc
3mm Lock Nut
....2 pc
....8 pc
2x8mm Socket Head Bolt
....2 pc
3x15mm Socket Head Bolt
....8 pc
2mm Hex Nut
....2 pc
3mm Lock Nut
....2 pc
Steel Joint Ball
....2 pc
Tail Blade Holder Bearing (Sealed)
....2 pc
Tail Blade Holder Bearing (Open)
....2 pc
Washer, 10x7mm (Large)
....2 pc
Washer, 7x4mm (Small)
....2 pc
Tail Thrust Bearing
Use Threadlock
TWO SETS REQUIRED
TWO SETS REQUIRED
2x10mm Flat Head Screw
Z,Q
Z,Q