JR ProPo Ergo Z230, Assembly Instructions Manual

Page: 22 / 72

4-3
MAIN BLADE HOLDER/SEESAW ATTACHMENT
4-4
SEESAW MIXING ARM INSTALLATION
22
*As Dampner Rubbers
will wear during use,
check regularly and
replace when necessary.
Thrust Bearing
Silver Grip Spacer
* Dampner Rubber
Blade Spindle Shaft
Steel Seesaw Spacer (2 pc)
Install into bearings from the inside prior
to sliding the seesaw shaft into position.
3x5mm Flat Head Hex
Screw (2 pc)
Seesaw
Shaft
12x16x0.5mm washer
Small I.D. (with line)
5x10mm Socket Head Bolt
(Use Threadlock)
Tighten securely using
two 4mm “L” Allen Wrenches.
Large I.D.
Caution: Be sure to note correct
placement of Large/Small I.D.
Thrust Washers during assembly.
*Steel Joint Ball (4pc)
*2x8mm Flat Head Screw (4pc)
3x4.5x.7 Washer (2pc)
3x15mm Socket Head Bolt (2pc)
Note: The four 2x8mm Flat Head
Screws and Steel Joint Balls are
pre-installed onto the Seesaw
Mixing Arms.
*The Seesaw Mixing Arms included with this
kit provide approximately 18° - 19° Total Pitch
Travel. For increased Pitch Travel for 3D flight
(23°), it is recommended that part
#JRP960178 Seesaw Mixing Arms be used.
5x10mm Socket Head Bolt
....2 pc
Thrust Bearing
......2 pc
Spindle Washer (Black)
......2 pc
Grip Spacer (Silver)
......2 pc
12x16x0.5mm Washer
......2 pc
3x5mm Flat Head Hex Screw
......2 pc
Seesaw Spacer (Steel)
Use Threadlock
Use Threadlock
Black Spindle Washer
TWO SETS REQUIRED
...2 pc
....2 pc
3x4.5x.7 Washer
3x15mm Socket Head Bolt
...2 pc
Z,Q
*Note: There are two different style Dampner Rubbers included in this
kit. The recessed, or hollow type is a 20 rating (soft). The solid version is
a 40 rating (medium) and is suggested for use with this kit.
(In some kits, the solid type (40 rating) Dampner Set
may be included in the instruction manual package.)
*Seesaw Mixing
Arms (2pc)
Z,Q