82
Removal and assembly of the Intake Manifold Assembly and Front lifting Lug:
1.
The Intake Manifold Assembly of the Carburetor Engine.
Fig.128 composing of intake manifold assembly of carburetor engine
Fig.129 composing of intake manifold assemble of electric injection engine
The intake manifold ‘s air may be preheated by the electrical heater as well as by coolant. As the
coolant’s temperature is lower than 60
°
, the electronic heater will be energized to facilitate the cold
starting.
The electrical heater’s energizing or deenergizing is controlled by the intake preheating switch and relay.
The intake preheating switch is installed in the M22 bolt hole in the thermostat seat(with the hole plugged by
plug screw for carburetor engine). The intake preheating switch’s operation parameters:
Switching off temperature: 63
±
4
°
Switching on temperature:
≥
52
°
Operation voltage: 6—24V
Electrical heater parameters:
…
Voltage: 15V Initial current:
≤
75A
Cold resistance: 0.2—0.4
Ω
temperature after 12-second energizing:
>
60
℃
temperature after
180-second energizing:
>
135
℃
3.3 Removal and assembly for the intake manifold assembly and front lifting lug:
Removal: ——Loose and remove two M8 lock nuts from the right front lifting lug.
——Remove the front lifting lug.