74
——Wrap a plastic tape on the oil seal journal of crankshaft avoiding to damage the edge of front
crankshaft oil seal.
——Apply engine oil on the edge of front crankshaft oil seal. Press the oil seal in place using appropriate
socket or sleeve and crankshaft pulley and pulley bolt and washers.
Fig.116
Fig.117
——Remove the thin plastic protective tape
5.
Removal and installation of oil filter and oil pressure sensor.
Removal
：
——Remove the oil filter. Rotate oil filter counterclockwise during
removal.
——Remove the oil pressure sensor Installation
：
——Apply engine oil on the sealing gasket of oil filter and screw into the connector. Tightening torque is
12
－
17Nm. Or screw into oil filter by hand. once rubber sealing gasket contacts cylinder block, tighten
another 3/4
－
1 turns.
——Apply Lotite 243 sealant and screw it to the main oil passage of cylinder block. Tightening torque is
25
－
29Nm.
The threaded hole of oil pressure sensor is 1/4
″－
18NPTF. The operating voltage of oil pressure sensor is
6
－
24V.
The starting warning pressure is 30
±
15kPa.
