70
The removal and installation of oil collector assembly
Removal
：
——Loosen locknut of oil collector assembly and take out the nut and flat washer
——Loosen carrier bolts and take out the bolts
。
washers
——Loosen flange face bolt of oil collector (two ) and take out the two bolts with spring
Installation
：
——Install a new sealing gasket of oil collector on the flange face of oil pump and then install oil collector
assembly.
Screw two bolts with gasket by hand.
Fig.101
Fig.102
——Screw the oil collector carrier into the cylinder body with M8 bolt. At the same time, hitch the carrier
into the stud which is in the left of the second bearing cap. Install the flat washer and screw in the nut by
hand.
——Tighten the flange face bolt of oil collector to 8.0—12.0Nm.
