137
Fig.208
5.
The reserve speed idler and the idler shaft are installed on the clutch housing. The idler shaft tap hole is
toward outside. The vertical distance from the center distance of tap hole to the faying face of clutch
housing is 82.5-83mm.
Fig.209
6.
The 2nd speed needle bearing bushing, the needle bearing, the synchronizer and 2nd driven gear are
installed. When the 3rd speed driven gear is installed, the shoulder side is toward the 2nd speed driven
gear.
Fig.210
7.
After the 3rd speed driven gear is installed, the axial size should be adjusted with the clamping ring. The
most suitable clamping ring is chosen from the following table. When installed, the clamping ring is not
excessively opened. And it is ensured to install in the groove of clamping ring.
Clamping Ring Type
Part Name
Thickness
015 311 381AA
2.8
015 311 381AB
2.9
015 311 381AC
3.0
015 311 381AD
3.1
015 311 381AE
3.2
