DP320 User's Manual
- 33 -
7. Check whether the paper specifications meet the standard request according to the Appendix
A.
Phenomenon 3: The paper does not eject completely.
Solutions:
1. May be the page length is too long. When using the pull tractor, tear off the paper having
entered the printer, then press the
LF/FF
button to feed the paper forward. When using the
push tractor, tear off the last paper printed out, then press the
LOAD/EJECT
button to feed
the paper backward.
2. Please make sure the paper length is within prescribed range. (Refer to the paper
specifications in Appendix A)
Phenomenon 4: When you switch between single sheets and continuous paper, the beeper
sounds once and the online indicator is off.
Solutions:
There is paper left in the paper in channel while you change the paper-release lever
position. Return the paper-release lever to the previous position and eject the paper.
Then change the paper-release lever position again.
4.5 Options
Using the pull tractor with the push tractor, continuous paper does not be fed properly
Paper feed is crooked or the paper jamed.
The pull tractor and push tractor sprockets are not aligned correctly. When using both tractors, be
sure that the sprockets on both are positioned evenly.
The paper may have too much slack. Adjust the position of the sprockets to take up any slack
along the width of the paper. Remove slack lengthwise by rotating the knob of the pull tractor.
The paper may be caught on the edge guides. Make sure that the paper guide is installed over
the paper and that the edge guides are positioned correctly.
Summary of Contents for DP320
Page 1: ...User s Manual DP320 Dot Matrix Printer...
Page 45: ......
