Jolimark DP320, User Manual

Page: 20 / 45

DP320 User's Manual
- 16 -
position set by the factory).
2.2.5 Feed Paper to the Tear Position
1. Turn on the printer, hold the
ONLINE
button 3 seconds till the
ONLINE
indicator is on with a
beep in the offline mode.
2. Hold the
TEAR
button 3 seconds that you can switch the function of feeding paper to the tear
position automatically
ON
or
OFF.
2.2.6 Other Functions of the Panel
Turn on the printer while holding some buttons, and then the printer will enter the special mode.
POWER
print setting mode
POWER+ LOAD/EJECT
Setup menu mode
LF/FF + POWER
Print pin test mode
TEAR + POWER
English self-test mode
TEAR + LF/FF + POWER
Hex dump mode
2.3 Paper Select Lever
Set paper select lever toward the single sheet or Tractor sheet position to select singlet sheet
mode or Tractor sheet mode.
2.4 Paper Feed Knob
The paper feed knob is used to feed paper manually or eject paper.
2.5 Adjusting the Paper-thickness Lever
The paper-thickness lever lets you specify the correct setting for your printing material. It is
factory-set for standard office paper. Here’s how to change the setting for special papers:
1. Turn the printer off and open the cover. The paper-thickness lever is on the left side of the
printer. The numbers next to the lever indicate the thickness setting. For normal use, the lever
should always be set to position 0.
Figure2-2 Paper-select lever
Figure2-3 Paper thickness adjust lever