Jolimark DP320, User Manual

Page: 19 / 45

DP320 User's Manual
- 15 -
ONLINE
indicator is on and the printer enters into the print mode.
Press this key in the offline mode, the printer is offline,
ONLINE
indicator is off and the printer can
not print.
2. If the paperr is at the tear position in the offline mode, press
ONLINE
button, the printer will go back
to the current page or the original print position of next page.
2.2.2 In the Single Sheet Mode
LF/FF
If the paper is at the print position in the offline mode, press the
LF/FF
button once (less than 0.5
second), the printer will feed the paper one line base on line spacing current set. Alternatively, hold the
LF/FF
button down, the printer will eject the paper until the single sheet is entirely ejected.
LOAD/EJECT
If the paper is at the print position in the offline mode, press the
LOAD/EJECT
button, the paper will be
entirely ejected from the printer.
ONLINE
If the printer has loaded paper in the offline mode, press the key to enter
ONLINE
mode, the
ONLINE
indicator is on and the printer enters into the print mode.
Press this key in the offline mode, the printer is offline,
ONLINE
indicator is off and the printer can not
print.
2.2.3 Print Speed
When printer is in the offline mode, holding the
ONLINE
button 3 seconds, the
ONLINE LED
is on with
a beep. The printer is in the alternate mode. Press the
PRINT SPEED
button to change the print mode
among Normal Speed mode, and High-Speed mode and Super High Speed mode. Press the
ONLINE
button again save the value and quit the alternate mode.
Speed
Speed LED
1 2
Normal speed
〇 〇
High speed
〇 ●
Supper high speed
● 〇
2.2.4 Micro-Adjust
1. After turning on the printer, install continuous paper properly using push tractor and feed paper
to the original print position.
2. Hold the
ONLINE
button 3 seconds till the
ONLINE
indicator is on with a beep in the offline
mode.
3. Press
UP
or
DOWN
button, with feeding paper upwards or ejecting paper downwards.
4. Press the
ONLINE
button again to save the setting and quit the alternate mode after finishing
adjusting. Before adjusting again, the original print position or the tear position will be effective
all the time. After the tear position is adjusted, press
ONLINE
button and you can send
commands to print. Only after the original print position is adjusted, the printer ejects all the
paper and feeds paper again, does it print.
The way of original print position adjusted between single sheet and continuous paper are the
same.
Note: The adjusted range of original print position is from -18/60 inch to +60/60 inch (base
on default position set by the factory).
The adjusted range of tear position is from -15/60 inch to +15/60 inch (base on default