DP320 User's Manual
- 10 -
NOTE: If the self test did not print satisfactorily, see Chapter 3. If it prints correctly, go on
to the next section.
1.9 Connecting the Printer to Your Computer
The printer configures a parallel interface
、
a USB interface and a Serial interface, Connect the
printer to the computer with the correct cables.
Before you begin, place the printer upright, as
shown below. (This makes it easier to connect the cable.)
Connect your computer to the desired interface as described below.
You can connect cables to both interfaces; the printer switches automatically to the appropriate
interface when it receives data.
Note: Before connecting the parallel interface or the serial interface, please make sure
the power of the printer is shut down. Only otter tined the cable, could the printer
be, or it will damage the printer.
1.9.1 Connecting to the Parallel Interface
You need a shielded, twisted-pair cable (not longer than 2 meters—6 feet) to use the parallel
interface.
1. Turn off both the computer and the printer. Plug the parallel cable connector securely into the
printer’s parallel interface. Squeeze the wire clips together until they lock in place on either
side of the connector.
2. Guide the interface cable through the slot on the side of the printer.
3. Plug the other end of the cable into the computer’s parallel interface.
Parallel interface
Serial interface
USB interface
Parallel interface
Figure1-24 Lay the backof printer upwards
Figure1-25 Connect to the parallel interface
Summary of Contents for DP320
Page 1: ...User s Manual DP320 Dot Matrix Printer...
Page 45: ......
