Jolimark DP320, User Manual

Page: 36 / 45

DP320 User's Manual
- 32 -
2. Check the page length set by your software and adjust it n the sofeware or in the printer to
match the paper length.
Phenomenon 2: Regular gaps occur in the printout.
Solutions:
Skip-over-perforation may be on. Set skip-over-perforation to off in the Printer Setting
mode. See “Changing the printer settings” on page 3.2.2.
4.4 Paper Handling
z
Single sheets do not be fed properly
Phenomenon 1: Paper does not feed.
Solutions:
1. Continuous paper may be left in the printer. Remove the continuous paper. Set the
paper-release lever to the single-sheet position. Insert a new sheet.
2. May be the sensor can not check there is paper if there is no continuous paper in the printer
and the paper-release lever is in the proper position. Try to move the paper a little left to make
sure to touch the paper in sensor.
Phenomenon 2: Paper feeding is crooked or the paper jamed.
Solutions:
Turn off the printer and pull out the jamed paper. Reinsert a single sheet straight into
the paper guide, and adjust the paper guide to match with paper width.Make sure that
the printer cover is closed, and power on again.
Phenomenon 3: Paper does not eject completely.
Solutions:
1. Use the
LF/FF
button to eject the page.
2. Make sure the printer cover is closed.
3. The paper may be too long. Check whether the paper used meets the specifications specified
in the Appendix, and the Using paper must be within the specified range. See the paper
specifications in the Appendix.
z
Continuous paper does not feed properly
Phenomenon 1: The tractor does not feed the paper.
Solutions:
1. Check that the paper-release lever is pulled forward to the continuous paper position. If not,
move the lever to the correct position.
2. If this problem still can not be sloved.The cause may be that the paper has come off the
tractor. Reattach the paper to the tractor.
Phenomenon 2: Paper feeding is crooked or the paper jamed.
Solutions:
1. Make sure the paper guide is in the upright position.
2. Make sure the position of your paper supply can not prevent it from feeding straight.
3. Make sure your paper supply is positioned within 1 meter (3 feet) off the printer.
4. Make sure the printer cover is closed.
5. Make sure the edge guide positions are correct. Position the edge guides at the
diamond-shaped guide marks.
6. Check that the holes on the both sides of the paper are aligned with each other. Also, make
sure the sprocket units are locked and their covers are closed.