Jolimark DP320, User Manual

Page: 22 / 45

DP320 User's Manual
- 18 -
Chapter 3 How to use the printer
Here are the steps of using printer:
1. Assemble the printer as the chapter 1, connect the printer to your computer and install the driver
correctly.
2. Load the correct type of paper
3. Set the printer if necessary.
4. Send the print command to the printer to print.
3.1 Attaching the Paper Supports
In addition to printing on single sheets and continuous forms, your printer can also print on a wide
variety of paper types, including multi-part forms, labels, and envelopes.
Caution: When printing on multi-part forms, thicker-than-normal paper, labels, or envelopes,
make sure your software program settings keep the printing entirely within the
printable area. Printing past the edge of these papers can damage the print head.
For multi-part forms and labels, you should not print any closer than 13 mm (0.5 inch) from either edge
of the paper.For information on the printable area of envelopes, see the Appendix.for instructions.
3.1.1 Printing on Single Sheets
1. Make sure the printer is powered off, and open the cover of the printer, select the correct GAP of
the printer thought the paper-thickness lever as shown in the illustration on page 2.5.
2. Close the cover, and set paper select lever toward the single sheet position.
3. Raise the paper guide upright, and turn on the printer.
Figure 3-1 Adjust paper thickness lever
Figure 3-2 Adjust paper-select lever