DP320 User's Manual
- 21 -
5. Make sure your paper has a clean, straight leading edge. Open the sprocket covers. Fit the first
holes of the paper over the sprocket pins and then close the sprocket covers. Slide the right
sprocket unit to remove any slack in the paper and lock it in place. Now the paper is in the
paper-park position.
Caution: Only paper jams are cleared when the printer is turned off, can use the knob
on the right side of the printer. Otherwise, you may damage the printer or
change the top-of-form position.
Note: Make sure your paper supply is positioned within 1 meter (3 feet) of the printer.
6. Hold the paper guide horizontally and install it according to the follow figure, then block it in the
direction shown by the arrow.
7. Slide the left edge guide to the center until it stops at the diamond-shaped guide mark. Then
slide the right edge guide to the opposite guide mark.
8. Make sure the printer cover is closed. Turn on the printer, and Press
LOAD/EJECT
to feed
paper. You can adjust the original print position of the page laypout according to chapter 2.2.4.
When the printer receives data, it begins printing automatically.
Figure 3-9 Load the continuous paper in the tractor
Figure 3-10 Install paper guide
Figure 3-11 Adjust the position of paper guide
Summary of Contents for DP320
Page 1: ...User s Manual DP320 Dot Matrix Printer...
Page 45: ......
