DP320 User's Manual
- 19 -
4. Slide the left edge guide until it locks in place at the triangular guide mark. Next, adjust the right
edge guide to match the width of your paper
5. Slide a sheet of paper down firmly between the edge guides until it meets resistance. The printer
loads the sheet and begins printing automatically.
6. If necessory, set the top-of-form position as shown in the illustration on page 2.2.2.
Note: Don’t feed the paper with Paper feed knob, or it will influence the paper not feeding
properly.
3.1.2 Printing on Continuous Papers
If you use the continuous paper, you must decide which tractor to be installed. Then you install the
tractor in the corresponding way.
For easy to switch between printing on single sheets and continuous paper, or easy to tear off
continuous paper sheet-by-sheet, you should use the tractor in push position.The printer comes
with the tractor installed in this position at the factory settings.
If you want to print on labels, you should use the tractor as a pull tractor.
You can use a push tractor and a pull tractor at the same time to strengthen the function of dealing
with the continuous papers, which is fit for the printing requiring high precision in the print position,
Figure 3-3 Raise the paper guide upright
Figure 3-4 Adjust the paper guide
Figure 3-5 Insert a single sheet
Summary of Contents for DP320
Page 1: ...User s Manual DP320 Dot Matrix Printer...
Page 45: ......
