Jetter JM-105, User Manual, Page: 87 / 106

JetMove 105 9.1 Error Messages
Jetter AG 87
9 Diagnostics
9.1 Error Messages
Note!
The ERR display of the output stage indicates the operating and fault conditions
of the digital servo amplifier JetMove 105. The different fault conditions are
displayed in Motion Setup.
Error Message Table - JetMove 105
Error
number Type of error Description Response to
faults Troubleshooting
F 00 Hardware error Internal hardware
defect – Immediate
motor power
disable
– Separate the drive
controller from the
power lines
– Return the amplifier for
repair
F03 Motor cable
breakage
(this error occurs
as of hardware
revision 2A.) The motor cable is
broken.
Be careful:
The motor cable is
tested when the
servo controller is
enabled for the first
time
– Immediate
motor power
disable
– Check the motor cable
connections
– Acknowledge failure
F 04 Overvoltage in the
DC link A DC link voltage of
>60 V has been
detected – Immediate
motor power
disable
– Check input voltage
supply
– If the motor is used as
generator, reduce the
regenerating power.
– Acknowledge failure
F 05 Over-current The output current
has been greater
than 2.5 x the rated
current or ground
fault during
operation – Immediate
motor power
disable
– Check cable and motor
for a short circuit and
ground fault
– Check current control
parameters. If
necessary, correct
parameters.
– Acknowledge failure