Jetter JM-105, User Manual, Page: 81 / 106

JetMove 105 7.10 Digital and Analog Inputs and Outputs
Jetter AG 81
*) is connected to the ground of the control system.
5 - 6 0 V Ground *)
7 - 9 Reserved Do not use
10 0 V Ground *)
11 Hardware
enable for the
power supply of
the motor
(input) • At this input, a high
signal is necessary for
power supply of the
motor. (This signal
must have been
applied before carrying
out the software
enable)
• A low signal de-
energizes the motor
immediately.
• DC 20 ... 30 V
• Input resistance: 3
KOhm
• Operating point:
< 4 V low,
> 14 V high
12 Reference
switch
(input) • Depending on the
parameter setting, this
input is used for
reference run
• DC 20 ... 30 V
• Input resistance: 3
KOhm
• Operating point:
< 4 V low,
> 14 V high
NC or NO contact
13 Positive limit
switch (input) • Depending on the
parameter setting, this
input is used as a
positive limit switch.
• DC 20 ... 30 V
• Input resistance: 3
KOhm
• Operating point:
< 4 V low,
> 14 V high
NC or NO contact
14 Negative limit
switch (input) • Depending on the
parameter setting, this
input is used as a
negative limit switch.
• DC 20 ... 30 V
• Input resistance: 3
KOhm
• Operating point:
< 4 V low,
> 14 V high
NC or NO contact
15 Digital input • Depending on the
parameter setting, this
input can be used for
quick stop, position
capture or referencing
without stop.
• DC 20 ... 30 V
• Input resistance: 3
KOhm
• Operating point:
< 4 V low,
> 14 V high