Jersey Jack Pinball The Hobbit, Operation Manual

Page: 14 / 347

Game Assembly & Setup
A-2
Figure A1. The “TRUCK THIS SIDE ONLY” side of the box.
DO NOT USE CLAMPS
MODEL:
COIN MECH:
COUNTRY:
SERIAL:
GAME NUMBER:
1645 OAK STREET
LAKEWOOD, NJ. 08701
PH. 732-364-9900
www.jerseyjackpinball.com
MADE IN
U.S.A
FRAGILE
UP UP
DO NOT DROP
®
1)
Using wire cutters, remove all shipping bands from the outside of the carton, noting
the side with the “TRUCK THIS SIDE ONLY” marking (see figure A1). With a utility knife
and needle-nose pliers, carefully cut the tape and remove all staples along the seams of
the carton’s top flaps, then fold them open (see figure A2). Remove the large, flat sheet
of cardboard. Pull out the large parts box (red in figure A2) and remove its contents.
Check all loose parts against the packing list on this page.
Figure A2. Opening the shipping carton.
Large Parts Box Packing List
4 pinball machine legs, with levelers and tightening nuts
8 acorn-head leg bolts
1 plumb bob weight, with nylon wing nut
5 steel mirror-finish pinballs
1 USA line power cable
1 “L”-shaped, 5/16” hex key
assorted spare game decals
spare set of slingshot plastics
assorted plastic game key fobs
game manual CD
Tools Required:
Wire cutters
Needle-nose pliers
Utility knife
Ratchet and 5/8” socket (or 5/8” wrench)
#2 Phillips screwdriver
Torpedo bubble level
Note:
If anything is missing from your parts box, send an email
to warranty@jerseyjackpinball.com for a replacement.
A.1
Unpacking Your Hobbit Game