39
This will expose the bottom of the sample
chamber with the power supply connection
needed to operate the active accessories.
8.2.3.1 Automatic 8 cell turret
Take the 8 cell turret base plate. Connect the
power supply in the bottom of the sample
chamber to the connector on the underside of the
base plate. Place the base plate in the sample
chamber. Replace screws 1 to 4.
Take the 8 cell carousel and place on top of the
motor, taking care to align the three ball bearings
with the grooves on the motor shaft. Gently push
the carousel down onto the motor shaft until it is
located into place. Gently rotate the carousel until
there is some resistance. The carousel is now in
the correct position.
If the fitting is too tight use a small screw driver to
loosen the ball bearings before pushing the
carousel down onto the shaft.
Summary of Contents for 7300
Page 1: ...Operating Manual 730 005 REV D 08 14 Model 7300 and 7305 Spectrophotometer...
Page 2: ...2...
Page 56: ...56 SECTION 11 Declaration of Conformity...
Page 57: ...57...
