41
8.2.3.3 Sipper pump
For this accessory as well as removing the
passive accessory base plate, the front panel
of the instrument must also be removed.
Loosen screws 5 and 6 until the front panel can
be lifted out in the forwards direction.
Take the sipper base plate. Connect the power
supply in the bottom of the sample chamber to
the connector on the underside of the base
plate. Place the base plate in the sample
chamber. Replace screws 1 to 4. Take the
sipper Peltier front panel and slot into place
before retightening screws 5 and 6.
The tubing should be connected depending on
the function that the sipper pump is going to
perform. All tubing must be kept as short as
possible and the tubing must not be allowed to
obstruct the ligth path.
5
6
Bi directional flow A
(sipping)
Bi directional flow B
(pumping)
Continuous flow
Summary of Contents for 7300
Page 1: ...Operating Manual 730 005 REV D 08 14 Model 7300 and 7305 Spectrophotometer...
Page 2: ...2...
Page 56: ...56 SECTION 11 Declaration of Conformity...
Page 57: ...57...
