49
To perform a measurement place the sipper tubing into
the sample and press the key below the sipper pump
icon.
Confirmation will be needed to start the sipper pump.
Press the key adjacent to the cross icon to cancel and
return to the operating menu. Press the key adjacent to
the tick icon to confirm and start the sipper pump. The
pump will run for the previously recorded sample take
up time. Ensure that the flow through
cuvette contains enough sample before pressing the key below the measure sample icon.
Once the measurement has been performed remove the tubing from the sample and press the key
below the sipper pump icon to perform the next stage of the calibration sequence.
Confirmation will be needed to start the sipper pump.
Press the key adjacent to the cross icon to cancel and
return to the operating menu. Press the key adjacent to
the tick icon to confirm and start the sipper pump. The
pump will run for the previously recorded air gap take
up time.
If an air gap of zero was previously selected this screen will not appear and the calibration sequence
will continue to sample disposal.
Once this stage of the calibration sequence is complete
press the key below the sipper pump icon to dispose of
the sample. Confirmation will be needed to start the
sipper pump. Press the key adjacent to the cross icon
to cancel and return to the operating menu. Press the
key adjacent to the tick icon to confirm and
start the sipper pump. Depending on the disposal route previously selected the sample will either go
to drain or back to the sample container.
Summary of Contents for 7300
Page 1: ...Operating Manual 730 005 REV D 08 14 Model 7300 and 7305 Spectrophotometer...
Page 2: ...2...
Page 56: ...56 SECTION 11 Declaration of Conformity...
Page 57: ...57...
