L
L
Connecting sensors NC (normally closed)
Require the connection of 10K resistors in series
2.5.2 The output maximum current provided through the
terminal AUX+ is '100mA (12V)
If you need a higher current, connect an extra 12Volt back up power.
In the case of black out of the 12 Volt output drops down , so the NC
motion sensors could report an alarm to the control panel.
3 Basic Settings
3.1 Factory default
Below you will find the basic factory default, you can modify them
according to your need.
-Administrator-Password: 9876
-User-Password: 1234
-Entry /exit delay time: 10 seconds
-Power line control : active
-Ringing time to pick up PSTN -phone for remote connection: 7
- Telephone line cut control: active
- Arm / disarm message report to CMS: OFF
-Timing arm/disarm : Off
-Autoarm / disarm time : 00:00
-Time for reporting arm / disarm (to CMS): 00:00
-Types of alarm siren ON (sound): burglar, perimeter, delayed,tamper,
fire, gas -
-Types of alarm siren OFF (not sound): emergency
-No phone number and system code stored
-Wired Zone: disable
-Dial out cycles for alarm: 5 times (not changeable)
-Monitoring-listening time: 10 seconds (not changeable)
WIRING & BASIC SETTING
e14
