Jeep Compass, Owner'S Handbook Manual

Page: 67 / 322

65
Warning light What it means
ESC DEACTIVATION
(where provided)
This warning light indicates that the electronic stability program (ESC) is deactivated.
Each time the ignition device is turned to RUN, the ESC system will be ON, even if it was turned off previously.
INJECTION / EOBD SYSTEM FAILURE
The engine check/malfunction warning light is a part of an On-Board Diagnostic System called EOBD that monitors
engine and dual clutch automatic transmission control systems. The warning light will turn on when the ignition
device is in the RUN position before the engine is started. If the warning light does not turn off, contact a Jeep
Dealership immediately.
Certain conditions, such as a loose or missing tank cap, poor quality fuel, etc., could cause the warning light to come
on after starting the engine. Contact a Jeep Dealership if it does not go off after having adopted other driving styles. In
most cases, the car can be driven normally without needing to be towed.
With the engine running, the warning light will blink to indicate dangerous conditions, such as imminent loss of power
or serious damage to the catalytic converter. In this case, immediately contact a Jeep Dealership.
64)
13)
AdBlue® (UREA) INJECTION SYSTEM FAILURE (Diesel versions)
The warning light appears, on some versions together with a dedicated message on the display, if a fluid not
conforming with nominal features is introduced or if an average AdBlue® (UREA) consumption of over 50% is
detected. In this case, contact a Jeep Dealership as soon as possible.
If the problem is not solved, a specific message will appear on the instrument panel display whenever a certain
threshold is reached until it will no longer be possible to start the engine.
When there are approximately 200 km before you will no longer able to restart the engine, on some versions a
dedicated message will appear fixed on the instrument panel display accompanied by warning tone.
TPMS
TPMS failure
If a TPMS failure is detected, the warning light flashes for about one minute and then stays on fixed. This sequence
will continue when the engine is started again for as long as the fault persists. When the warning light is on, the
system may not be able to correctly detect or signal low tyre pressure. TPMS malfunctions may occur for a variety of
reasons, including the installation of replacement or alternate tyres or wheels on the car that prevent the TPMS from
functioning properly. Always check the TPMS warning light after having replaced one or more tyres or wheels on the
car to establish that the replacement tyres and wheels allow correct operation of the TPMS.