Jeep Compass, Owner'S Handbook Manual

Page: 268 / 322

MULTIMEDIA
266
monitor the following parameters:
acceleration/deceleration/gear
shift/speed.
eco:Drive view
Press the eco:Drive™ button to interact
with the function.
A screen will be displayed showing the 4
indices described above. These indices
are gray until the system has enough
data to evaluate the driving style.
Once sufficient data are available, the
indices will have 5 colors depending on
the evaluation: dark green (very good),
light green, yellow, orange and red (very
bad).
"
Current trip index " refers to the entire
value calculated in real time based on
the average of the described indices. It
represents eco-friendliness of the driving
style: from 0 (low) to 100 (high).
In the event of extended inactivity, the
display will show the average of the
indices up to that moment (the " Average
Index ") then the indices will be colored
again in real time as soon as the car is
restarted.
If you want to confirm the data averages
from the previous trip (by "trip" a cycle
of positioning the ignition device in RUN
and later in STOP is meant), select the
graphic button " Previous Route ".
The details of the previous trip can also
be displayed by pressing the " Details "
button to show trip duration (time and
mileage) and average speed.
Trip data storage and transfer
The trip data can be stored in the system
memory and transferred using a suitably
configured USB memory stick or by
Uconnect™LIVE App . This allows you to
display the history of the collected data,
showing the complete analysis of the trip
data and of your driving style.
More information is available on the
www.driveuconnect.eu site.
WARNING Do not remove the USB
memory stick nor unpair the smartphone
and the Uconnect™LIVE App before
the system has downloaded the data,
since these could be lost. During the
transfer of data to the devices, messages
may appear on the radio display to
guide the user correctly through the
operation; follow these instructions.
These messages are viewed only on the
starter device in STOP position and when
a delay is set in turning off the system.
The data are automatically transferred to
the devices when the engine is switched
off. Transferred data will be deleted from
the system memory in this manner. You
can choose to store the trip data or not,
by pressing the " Settings " button and
setting the storage activation and the
USB or Cloud transfer mode.
When the USB key memory is full, the
radio screen will show messages to that
effect.
When the
eco:Drive™ data have not been
transferred to the USB key for a while,
the internal memory of the
Uconnect™
LIVE system could fill up: in this case,
follow the recommendations provided by
the messages on the Uconnect™ screen.
my:Car
my:Car allows you to keep the condition
of your car always under control.
The my:Car application is capable of
detecting malfunctioning in real time
and lets the driver know about the expiry
of maintenance coupons.
To interact with the application, press
the graphic button "my:Car": on the
screen there is a section "care:Index"
where all the detailed information on the
car status will be shown.
Pressing the graphic button "Active
signaling" you can see (if there are any)
the details of the fault detected on
the car which has caused a warning
light/symbol to go on.
The car's status can be viewed on both
the www.driveuconnect.eu and via the
Uconnect™LIVE App.
Mopar
®
Connect (where provided) offers a
new set of services dedicated to safety
and vehicle remote control which
integrate the Uconnect™ LIVE services.
For further information go to the
www.driveuconnect.eu website.