Jeep Compass, Owner'S Handbook Manual

Page: 142 / 322

STARTING AND DRIVING
140
With brake pressed, if the gear lever is
in "AutoStick" mode, the engine can be
restarted moving the lever to "+" or "
–
", or
R (Reverse) or N (Neutral).
When the engine has been stopped
automatically, keeping the brake pedal
pressed, the brake can be released
keeping the engine off by quickly shifting
the gear lever to P (Park). To restart
the engine, just move the lever out of
position P.
MANUAL SYSTEM
ACTIVATION/DEACTIVATION
To activate/deactivate the system
manually press the button on the
central tunnel fig. 97.
97
5520315D
System Activation
The system activation is indicated by the
LED on the button fig. 97 that turns offs.
System Deactivation
The system deactivation is indicated by
the LED on the button fig. 97 that turns
on.
WARNING
237) Before opening the hood, make
sure that the engine is off and that the
ignition is in the STOP mode. Follow the
indications on the plate underneath the
hood. We recommend that you remove
the key fob if other people remain in the
vehicle. Leave the vehicle after the key
fob has been removed and the ignition
is turned to the STOP mode. During
refueling, make sure that the engine is off
(ignition device in STOP mode).
IMPORTANT
49)
When replacing the battery, always
contact a Jeep Dealership. Replace
the battery with the same type (EFB -
Enhanced Flooded Battery) and with the
same specifications.
50)
If you prefer climatic comfort, you
can disable the Stop&Start system to
allow continuous operation of the climate
control system.
SPEED LIMITER
(where provided)
DESCRIPTION
This system allows you to limit the
vehicle speed to values programmed by
the driver.
It is possible to program the maximum
speed while the vehicle is stationary or in
motion.
When the device is active, the vehicle
speed depends on the pressure at the
accelerator pedal, until the set speed
limit is reached.
ACTIVATING THE SYSTEM
To activate the system, press the
button on the steering wheel fig. 98.
98
5520316D
The functions of the steering wheel
buttons are as follows:
SET + : quick speed limit programming
(saves a higher value);