Jeep Compass, Owner'S Handbook Manual

Page: 47 / 322

45
Icon Description
REAR
Rear defrost button
Push and release this button to turn on the heated rear window and the heated outside mirrors (where provided).
When the heated rear window is activated the corresponding LED lights up. The heated rear window deactivates
automatically after ten minutes.
/
/
Driver and passenger side temperature up and down buttons
This provides the driver and passenger with independent temperature control. Push the button on the
control panel or on the touchscreen or press and slide the temperature bar towards the blue button
on the touchscreen for warmer temperature settings. Push the blue button on the control panel or on
the touchscreen or press and slide the temperature bar towards the button on the touchscreen for cooler
temperature settings.
Sync
Sync button
Press the Sync button on the touchscreen to toggle the Sync feature on/off. The Sync (Synchronisation) icon is
illuminated when this feature is enabled. The Sync (Synchronisation) icon is used to synchronise the passenger
side temperature setting with the driver side temperature setting. Changing the passenger temperature setting
while in Sync mode will automatically exit this feature.
NOTE The Sync (Synchronisation) button is only available on the touchscreen.
Knobs on the control panel
Buttons on the touchscreen
Fan control
Fan control is used to regulate the amount of air forced through the climate system. There are seven fan speeds
available. When you adjust the fan, you go from automatic to manual operation. The speeds can be selected
using either the fan control knob on the control panel or the buttons on the touchscreen.
Control panel:
The fan speed increases as you turn the fan control knob clockwise from the lowest fan setting.
The fan speed decreases as you turn the fan control knob anticlockwise.
Touchscreen: use the small fan icon to reduce the fan setting and the large fan icon to increase the fan
setting. The fan can also be selected by pressing the fan bar area between the icons.
“MODE” Button
Push the button in the centre of the fan control knob to change the airflow distribution mode. You can also
change the mode by pressing the desired mode on the touchscreen. The airflow distribution mode may be
adjusted so that air flows from the dashboard vents, from the floor vents or from the defrosting and demisting
vents. The mode settings are as follows: