JDS Uniphase 4100, User Manual, Page: 54 / 182

Chapter 4
Configuring the reflectometry test
Configuring the test in OTDR Expert
34
User Manual 770000102/08
This configuration file can be selected in SmartOTDR™ (see "Selecting
the configuration file" page 18 ) or loaded for ExpertOTDR.
Loading an
existing
configuration
file in
ExpertOTDR
To load a configuration file previously created or available in the T-BERD/
MTS and apply parameters to new OTDR Expert tests:
From the File Explorer page
1
Press
F
ILE hard key
2
Select the configuration file desired
3
Press
Load
>
Load Config.
– Press
S
ETUP hard key to display the OTDR acquisition parameters
saved in the selected configuration file.
You can modify some acquisition or file storage parameters, and save
them in a new configuration file (see
“Saving configuration parameters in
a file” on page 33 ).
From the Setup page
1
Select one header in either Setup page (Acquisition, Link, File...)
2
Press
Load Config.
menu key.
The file Explorer page displays
3
Select the configuration file desired
4
Press
Load Config.
to load the configuration file for acquisition in
OTDR Expert mode.
A sound is emitted to confirm the loading.
The
Setup
screen is displayed again.
If the menu key
Load as SMART Config.
is pressed, the configura-
tion is applied for acquisition in OTDR Expert, and in SmartOTDR™
mode too.
NOTE
Some configuration files are available into the equipment, in
disk/
config
.
MTS2100 4100 Module US rev08.book Page 34 Jeudi, 1. août 2013 1:43 13