JDS Uniphase 4100, User Manual, Page: 151 / 182

Chapter 9
File management
File Setup menu
User Manual 770000102/08 131
Filenaming convention in Cable View
In Cable View, the filenaming convention is as follows:
[Cable_Id]
As soon as the Cable Id changes, the result table is cleared and the next
tests are stored with the new Cable Id name.
The table view can be modified in the
Setup
page (see Figure 72 on
page 112 ).
Filenaming convention for Fault Finder results
If the fault finder is selected, the fault finder sor trace is using the
following filenaming convention:
[Cable_Id][Fiber_Id][Fiber_Num]
Default Filename for LTS results
Press
Default Filename
in the LTS tab allows to apply the following
name by default for LTS results:
Fiber[Cable_Id][Fiber_Num]_[Lambda]_[Direc-
tion][Pulse]
Name of a file
After an acquisition, and as long as the result has not been saved, the
line below
Filenaming
gives the name made up in accordance with the
filenaming rules.
If the file has been recalled from a memory, the line below
Filenaming
shows its name irrespective of whether it respects the current filenaming
rules.
This name can then be modified by calling up the edit menu using the
button
. If a modification is then made to the filenaming rules, the file
name will not be modified. To return to a name made up in accordance
with the filenaming rules, simply delete the existing name.
Save mode
When a trace or more is displayed, in the parameter
Save Mode
, you can
select three types of methods for storing traces:
Editing the name enables the trace to be saved in a new file (with a
new name), but it cannot rename the existing file (this function is pos-
sible in the
Explorer
menu). Thus the new name will not be taken into
account until the trace is saved again.
MTS2100 4100 Module US rev08.book Page 131 Jeudi, 1. août 2013 1:43 13