JCM GAMMA VERSUS Series, Manual

Page: 68 / 111

GAMMA VERSUS MANUAL
68
COD. 1257066 Gamma VERSUS Manual v1.13
7.31 TAMPER function
door. Once finished, the exit maneuver is desactivated.
• Using an options selector it is posible to activate the automatic opening function due to
deactivation of the signal fire. This function allows you to automatically open the door
once this has closed due to the activation of a fire signal and this signal is then turned
off. To assign this function to a selector options, it is necessary to configure one of the
configuration parameters P54 ... P5C. This function is not compatible with the automatic
opening fire signal function (parameter PD7).
Notes
Model Models with TAMPER input available (M22)
Associated
parameters
ID Description Type
P78…P90 OUT XX OUTPUT
PE0 TAMPER activations counter NUMERIC
Description TAMPER function allows the installer to configure an output of the control panel in order
to inform on the box tampering. This output can be used to control an alarm, warning
siren, etc.. You can also control the number of manipulations by a counter that can be
accessed and reset by VERSUS-PROG.
Configuration To enable this function, you must assign a TAMPER output in one of the control panel
outputs. This assignment is done using configuration parameters
P78 ... P90 .
Operating Some models of VERSUS control panels incorporate a TAMPER type input that allows
the installation of a switch that controls the opening of the cover of the box. When the
cover of the control panel box is opened, tamper output is activated indicating the
manipulation of the control panel. The opening of the cover is recorded by the activations
counter parameter that can be accessed and reset by the programming tool.
Notes